Skip to main content
Training & Workouts

FTP: Manual vs Estimated (eFTP)

Written By Martijn Russchen

Last updated 13 days ago

IntervalCoach can plan and analyse your training from either an automatically estimated FTP (eFTP) or a manual FTP you set yourself. You choose which under Settings → Training → FTP preference, and you set the values themselves under Settings → Training → Thresholds & zones.

The two options

  • Estimated FTP (eFTP): the default. Estimated from your recent ride power and updated automatically as you train. It only moves up when you ride hard efforts of a few minutes or longer, so if you mostly ride steady or very short intervals it can lag behind your real fitness.

  • Manual FTP: the FTP you enter under Thresholds & zones, for example from a test. It stays fixed until you change it. Good for conservative training, or when you're easing back after time off.

Your choice sets the FTP IntervalCoach plans and analyses with: your power zones, session scores, intensity choices and cross-sport equivalency.

What you feel on the bike

When IntervalCoach sends a ride straight to your Garmin, Wahoo or Hammerhead, the watts are worked out from your FTP in IntervalCoach (your Indoor FTP for trainer rides), and a change to your FTP sends the workout again. Apps that run the workout themselves, such as Zwift, turn the percentages into watts with the FTP in their own profile. So if you train in such an app, use the same number there as in IntervalCoach, or the watts on your trainer won't match the plan.

A separate FTP for indoor rides (Indoor FTP)

Many riders hold less power on the trainer than on the road, or their smart trainer and power meter read differently. You can give indoor rides their own FTP: fill in Indoor FTP under Settings → Training → Thresholds & zones. When it's set, it is used for every indoor ride instead of the FTP your preference picks.

  • Completed rides marked as indoor or on a trainer are calculated against your Indoor FTP, for load, zones and analysis.

  • Planned rides use your Indoor FTP when they are marked as indoor. If you ride mostly indoors, set Settings → Training → Indoor / outdoor bias to Indoor and every planned ride is marked indoor. If you mix indoor and outdoor, switch a single session to indoor on its own page or ask Coach+.

  • A test ridden indoors goes into your Indoor FTP when you choose to use the result, so check that number afterwards.

  • eFTP is a single estimate built from all your rides, so with two devices that read differently, manual FTP plus Indoor FTP is the cleaner setup. If nearly all your riding is on the same trainer, you don't need a separate Indoor FTP.

Runners: pace preference

Runners get the same choice for pace under Settings → Training → Pace preference (shown when running is one of your sports):

  • Critical Speed (CS): the default; estimated automatically and adapts to your fitness.

  • Threshold Pace: the value you set under Thresholds & zones; good for conservative training.

Run targets on your watch use your threshold pace. Without one we use your Critical Speed where we can, so set a threshold pace to be sure.

Where the values come from

Your manual FTP, Indoor FTP and threshold pace are the values under Settings → Training → Thresholds & zones; change them there and everything that uses them follows. If you've connected Intervals.icu, we also send them there. Your eFTP and Critical Speed update automatically from your training data as it comes in. Not sure which FTP is right? Ask Coach+ for a 20-minute FTP test: afterwards you get a test report with the option to use the new value.